Extreme Networks ExtremeWare 7.3.0, Справочник по командам

Страница: 101 / 2254

show switch
ExtremeWare Software 7.3.0 Command Reference Guide 101
• NVRAM configuration information (primary/secondary configuration, date/time, size, version)
• PACE configuration information
• Software licensing information
• MSM information (BlackDiamond switch only)
• Mode of switch operation (Alpine 3802 only)
• Default configuration mode (standard or enhanced)
This information may be useful for your technical support representative if you have a problem.
Depending on the software version running on your switch, additional or different switch information
may be displayed.
Example
The following command displays current switch information:
show switch
Output from this command looks similar to the following:
SysName: Alpine3804
SysLocation: Extreme Networks HQ
SysContact: Carlos_Beronio
System MAC: 00:01:30:23:C1:00
License: Full L3
System Mode: 802.1Q EtherType is 8100 (Hex). CPU Tx-Priority = High
RED Probability: 0
DLCS: Enabled
SysHealth Check: Enabled. Alarm Level = Log
Recovery Mode: All - System-dump/Reboot
Transceiver Diag: Enabled. Failure action: log only
Fdb-Scan Diag: Enabled. Failure action: log only
System Watchdog: Enabled
Reboot Loop Prot: Disabled
Current Time: Tue Jun 10 07:39:40 2003
Timezone: [Auto DST Enabled] GMT Offset: 0 minutes, name is GMT.
DST of 60 minutes is currently not in effect, name is not set.
DST begins every first Sunday April at 2:00
DST ends every last Sunday October at 2:00
Boot Time: Wed Jun 4 11:52:38 2003
Config Modified: Mon Jun 9 15:09:44 2003
Next Reboot: None scheduled
Timed Upload: None scheduled
Timed Download: None scheduled
Temperature: Normal. All fans are operational.
Power supply: Upper (PSU-A) not present, Lower (PSU-B) OK
Image Selected: Primary
Image Booted: Primary
Primary EW Ver: 7.0.0b61 [unknown-ssh]