Extreme Networks ExtremeWare 7.3.0, Справочник по командам

Страница: 1995 / 2254

configure debug-trace wireless ports iapp
ExtremeWare Software 7.3.0 Command Reference Guide 1995
configure debug-trace wireless ports iapp
configure debug-trace wireless ports [<portlist> | all] iapp <debug-level>
Description
Enables debug tracing for Inter-Access Point Protocol (IAPP) on a per interface basis to troubleshoot
IAPP scenarios.
Syntax Description
Default
Disabled.
Usage Guidelines
IAPP uses layer 2 updates to allow connected layer 2 devices to update forwarding tables with the
address of the client. The access point (AP) sends the updates on behalf of the clients by inserting the
MAC address of the mobile station in the source address. The switch looks up the UDP request packet
on the local subnet that contains the AP’s MAC address which contains the needed IP address. All APs
on the subnet receive this message. The AP with the matching MAC address sends a unicast response
packet with its IP address.
Example
The following example enables debug tracing for IAPP on port 1:15 with a debug level of 2:
configure debug-trace wireless ports 1:15 iapp 2
History
This command was first available in ExtremeWare 6.2a and added to the “ i ” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
debug-level Specifies a debug level in the following range (0-7). The default is 0 (off).