Extreme Networks ExtremeWare 7.3.0, Справочник по командам

Страница: 654 / 2254

654 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
configure sys-health-check scan-recovery
configure sys-health-check scan-recovery [reset | remap]
Description
Configures the system health checker to reset the module with or without diagnostics.
Syntax Description
Default
Reset module and run diagnostics (remap).
Usage Guidelines
Extreme Networks support personnel can configure the action taken by the system health check if
diagnostics are run or if checksum errors trigger diagnostics. If diagnostics are run or triggered in
previous releases of ExtremeWare, the module is reset and diagnostics are run. Support personnel can
use the following command to configure ExtremeWare to simply to reset the module without running
diagnostics:
configure system-health-check scan-recovery [reset | remap]
Entering this command generates the following message:
This command should only be used at the direction of Extreme Personnel. Do you wish
you continue (y/n)?
Answering
y
immediately implements the change. Answering
n
implements no change and returns you
to the command line.
Use the
reset
option to reset the module without running diagnostics. This option is useful for
recovering from transient hardware failures. In these cases, resetting the module stops the checksum
errors.
Use the
remap
option to reset the module and run diagnostics. This is the default.
This command is not available on the BlackDiamond 6816.
Example
The following command configures the system health checker to reset the module without running
diagnostics:
configure sys-health-check scan-recovery reset
History
This command was first available in ExtremeWare 7.2.0b25.
reset Resets the module without running diagnostics.
remap Resets the module and then runs diagnostics. This is the default option.