-3.5 to 3.5 mm (0.0 mm default)
Scan Reg1
Adjusts the start position for printing in the horizontal direction. The start position shifts to
the right as the value increases. This setting is available for single-sided printing and for the
back of duplex printing.
-3.5 to 3.5 mm (0.0 mm default)
Feed Reg2
Adjusts the start position for printing in the vertical direction. The start position shifts down as
the value increases. This setting is available for the front of duplex printing.
-3.5 to 3.5 mm (0.0 mm default)
Scan Reg2
Adjusts the start position for printing in the horizontal direction. The start position shifts to
the right as the value increases. This setting is available for the front of duplex printing.
-3.5 to 3.5 mm (0.0 mm default)
Highland:
Adjusts the print quality when using the printer at high altitudes. Increasing the value makes the
printer more suitable for high altitudes.
0 to 3 (0 default)
Charging Roller Voltage:
Adjusts the print density by correcting for the voltage of the charging roller. The printout becomes
lighter as the value increases.
1 (dense) to 5 (light) (3 default)
Drum Refresh:
Refreshes the drum. This may help to reduce smears on the print outs. Note that before refreshing the
drum, make sure no paper is loaded in the paper tray.
Drum Refresh with paper:
This may help to reduce smears on the print outs. Select this menu if Drum Refresh does not reduce
smears on the print outs sufficiently. Make sure you load A4 or A3 size plain paper in the paper tray.
Automatic Drum Refresh Length:
Specifies the length of time at which the printer refreshes the drum automatically.
(4 min default)
Drum Refresh Counter:
Displays the number of times that Drum Refresh has been done.
Drum Heater:
Controls the drum heater. Selecting
On
prevents image quality from degrading while the printer is
not used for a long time if it is located in a very humid environment. This increases power
consumptions, but inhibits the printer's automatic drum refreshes. Drum heater control is enabled as
long as power is being supplied.
>
>
203