Docomo FOMA P2403, Руководство пользователя

Страница: 151 / 180

AT
Command
List
AT Command List
AT command
AT ¥ S
[M]
AT ¥ Vn
[M]
[&F][&W]
AT%V
[M]
AT&Cn
[M]
[&F][&W]
AT&Dn
[M]
[&F][&W]
AT&En
[M]
[&F][&W]
AT&Fn
[M]
AT&Sn
[M]
[&F][&W]
AT&Wn
[M]
AT ＊ DGANSM=n
[M][?][=?]
Outline
Displays the contents of
each command and S
register currently set.
Selects the result code
specification for when
the line is connected.
Displays the version of
the FOMA terminal.
Selects the operating
condition of the circuit
CD signal to DTE.
Selects the operation
which is carried out
when the circuit ER
signal received from
DTE transits between
ON and OFF.
Selects the speed
display specification for
connection.
Restores all the registers
to factory set values. If
the command is entered
during communication,
the line is disconnected.
Sets the data set ready
signal to be output to
DTE.
Stores the current set
values.
Sets the reject/accept
mode for the packet
incoming call. This
command is valid for
incoming calls during the
packet communication
after entering the setting
command.
Description of parameters
−
n=0
：
An extended result code is not
used (setting at purchase).
n=1
：
An extended result code is used.
−
n=0
：
CD is always ON.
n=1
：
CD changes in accordance with
the carrier of the other party's
modem (setting at purchase).
n=0
：
Ignores the ER status. (assumed
to be always ON.)
n=1
：
When ER changes from ON to
OFF, it becomes an on-line
command mode.
n=2
：
When ER changes from ON to
OFF, it becomes an off-line
command mode after
disconnecting the line (setting at
purchase).
n=0
：
Displays communication speed
between radio wave blocks.
n=1 ： Displays DTE serial communication
speed. (setting at purchase)
Only n=0 can be specified (can be
omitted).
n=0
：
DR is always ON. (setting at
purchase)
n=1
：
DR is turned ON when the line is
connected (when the
communication is established).
Only n=0 can be specified (can be
omitted).
n=0
：
Invalidates the incoming call
reject/accept settings.
(setting at purchase)
n=1
：
Validates the incoming call reject
setting (AT
＊ DGARL).
n=2
：
Validates the incoming call accept
setting (AT
＊
DGAPL).
Command execution
example
AT ¥ S
(
☛
page 158)
OK
AT ¥ V0
OK
AT%V
Ver1.00
OK
AT&C1
OK
AT&D1
OK
AT&E0
OK
−
AT&S0
OK
−
AT ＊ DGANSM=0
OK
149