Address
Sets the address in the address field. Enter a numeric value between 0 and 255 in
each field of "aaa.bbb.ccc.ddd." However, 127 and 224 to 254 cannot be used to
"aaa."
Address Mask
Sets the Subnet Mask in the mask field. Enter a numeric value between 0 and 255 in
each field.
Active
Mode
Reject
Rejects printing from specified network address.
Permit
Permits printing from specified network address.
Disabled
Disables the IP Filter feature for the specified IP address.
When you make the settings for the filter, enter the IP address of the IP Filter in the
Address
field and the
Subnet Mask in the
Address Mask
field. Enter a numeric value between 0 and 255 in each field. "
*
" is
appended to the current value.
Setup Procedure
You can set up to a maximum of five items and the first item takes priority. Enter the shortest address first
before proceeding to the next longer address when setting multiple filters.
The following section explains how the
IP Filter
operates.
IP Filter Procedure
Enabling Printing From a Specified User
The following describes the procedure to enable printing only from the "
192.168.100.10
" IP address.
Procedures:
Click the first column of
Access List
row
1
.
1.
Enter "
192.168.100.10
" in the
Address
field and "
255.255.255.255
" in the
Address Mask
field.
2.
Select
Permit
.
3.
Click
Apply New Settings
.
4.
Disabling Printing From a Specified User
The following describes the procedure to disable printing only from the "
192.168.100.10
" IP address.
Procedures:
Click the first column of
Access List
row
1
.
1.
Enter "
192.168.100.10
" in the
Address
field and "
255.255.255.255
" in the
Address Mask
field.
2.
Select
Reject
.
3.
Click the first column of
Access List
row
2
.
4.
5.
6.
Содержание 3110 Color Laser
