To avoid potential paper feeding problems and uneven print quality, there are several things you can do.
To achieve the best possible print quality, store print media in an environment where the temperature
is approximately 21°C (70°F) and the relative humidity is 40%.
Store cartons of print media on a pallet or shelf, rather than directly on the floor.
If you store individual packages of print media out of the original carton, make sure they rest on a flat
surface so the edges do not buckle or curl.
Do not place anything on top of the print media packages.
Storing Consumables
Store consumables in their original packaging until you need to use them. Do not store consumables in:
Temperatures greater than 40°C (104°F).
An environment with extreme changes in humidity or temperature.
Direct sunlight.
Dusty places.
A car for a long period of time.
An environment where corrosive gases are present.
An environment with salty air.
Replacing Print Cartridges
CAUTION:
Before performing any of the following procedures, read and follow the safety
instructions in your
Owner's Manual
.
NOTICE:
To protect the drums of the print cartridges against bright light, close the front cover within
5 minutes. If the front cover remains open for more than 5 minutes, print quality may deteriorate.
Dell print cartridges are available only through Dell. You can order more cartridges online at
http://www.dell.com/supplies
or by phone. To order by phone, see your
Owner's Manual
.
Dell recommends Dell print cartridges for your printer. Dell does not provide warranty coverage for problems
caused by using accessories, parts, or components not supplied by Dell.
CAUTION:
Never throw used print cartridges into a fire. The residual toner could explode
resulting in burns and injuries.
Содержание 3110 Color Laser
