X-320M™ User's Manual
Installation and Setup
The TCP port used for HTTP communications (web browser, xml, get commands) with X-320M™ is
specified here. The default setting for this field is 80, which is the standard HTTP port. It is
recommended that the port be left unchanged, unless the user has an understanding of TCP/IP and
ports. For more information on TCP ports and IP addressing see
Appendix C: Accessing X-
320M™ Remotely Over the Internet
.
Speed
This option sets the data rate (clock rate) of the Ethernet port. Either
10 Mbps
or
100 Mbps
can be
selected. The
100 Mbps
option offers faster communications, but the amount of data to and from X-
320M™ is so small that users will not likely notice much (if any) difference. When X-320M™ is set to
10 Mbps
, it draws less power and runs a little cooler, which may translate into a longer product life.
The default setting for this field is
10 Mbps
.
IT IS RECOMMENDED THAT THIS SETTING BE LEFT AT
10 Mbps
UNLESS THE USER HAS A
SPECIFIC REASON TO USE
100 Mbps.
Mode
This option allows the Ethernet port to be set to
Half Duplex
or
Full Duplex
. Legacy Ethernet
operates in
Half Duplex
mode, which means that devices can either send data or receive data, but
not both at the same time.
Full Duplex
means that devices can send and receive data at the same
time. The default setting for this field is
Half Duplex
.
Mail Server (SMTP)
The name of the SMTP (Simple Mail Transfer Protocol) mail server (for example mail.example.com)
or the IP address of the mail server (for example 192.10.10.10) should be entered in this field. There
is no default setting for this field.
Note: If the server name is entered and not the IP address, the address of a DNS server will be
required.
Mail Server Port
This field is used to specify the SMTP Mail Server Port. The default setting is 25, which is the
standard SMTP port.
User Name (If Required)
If the SMTP mail server requires authentication, the user name must be entered here. There is no
default setting for this field.
Password (If Required)
If the SMTP mail server requires authentication, the password must be entered here. There is no
default setting for this field.
Return Email
X-320M™ will not receive email messages, but when X-320M™ sends email messages, it must
include a return email address. This field is used to specify the return email address. Note that
although X-320M™ will send email messages with any email address specified in this field, some
email filters (spam filters) will not allow messages through that include an invalid email address.
There is no default setting for this field.
Email 1 to Email 5
Enter the email addresses of up to five recipients for alarm messages in these fields. There are no
default settings for these fields.
Email Length
By default an email message contains the status of all the sensors that are visible on the status
page. When the
Small Email
option is selected, only the status of the sensor that triggered the
email will be present. This is useful when sending emails to smart-phones, etc.
Xytronix Research & Design, Inc.
Page 35
Содержание X-320m
Страница 1: ......
