Collamat Etiprint Inline, Руководство по эксплуатации

Страница: 32 / 188

Etiprint Inline
Installation
32
6.5 Electrical connection
1. Connect the equipment mains cable to the local electrical
power supply (see name plate for connected voltage). Have
regard to stumbling hazards when laying cable.
2. Connect control lines e.g. product sensor (see electrical
circuit). Have regard to the safety aspects when laying the
lines.
Labeller:
The labeller signals and drive motor feeds are routed to the Etiprint
Inline from the Monitor 8600/9100 via two dedicated cables. These
are through connected via two cable entries. They are permanently
connected to the Etiprint Inline and can only be disconnected at the
Monitor 8600/9100.
The product sensors and speed detection are connected at the
interface in accordance with the
Collamat 8600 Technical
Handbook . The terminals for these signals are to be found on thee
interface under the Etiprint Inline cover.
The drive motor must be connected in accordance with the
Collamat 8600 Technical handbook . The motor is also
connected here at the interface.
(See also electrical circuit in the appendix)
6.6 Inspection after completion of the installation work
Check for correct installation.
Check operating company’s installed safety equipment for
completeness, condition and safe function.
Instruct operating personnel and determine the location
where the Operating Instructions are to be kept.
After complete installation and inspection of the equipment
as well as instructing the operating personnel, the equipment
is ready for commissioning.