Collamat Etiprint Inline, Руководство по эксплуатации

Страница: 135 / 188

Error #11 Drive not Ready
Cause:
The motor drive card indicates that it is not ready to drive the stepper motor.
Solution:
Switch off the monitor. Wait 10 seconds before switching on again. If the error did not disap-
pear, the monitor is damaged and has to be repaired by a specialist.
Error #12 Undervoltage
Cause:
During labelling a mains occurred causing the data to be backed up.
The monitor continues to operate normally.
Error #13 Profiling speed
Cause:
The max. profiling speed exceeds the maximum permissible labeller speed.
Solution
Reduce the goods speed or possibly increase the max. labeller speed.
Error #14 Watchdog Timer
Error #15 Division by zero
Cause:
An internal protective circuit has detected that the calculation time provided is exceeded or a
calculation error is in the processor. The cause may be a very strong electromagnetic disturban-
ce or a program error.
Solution:
Switch off and on the monitor. If the error persists, please note all monitor settings and contact
your technical supporter.
Error #16 Predisp. too short
Cause:
At the actual measured speed the brake ramp exceeds predispensing.
Solution:
Reduce the good speed or increase predispensing.
5999.530-01F 07.04.2006 WM

48