Collamat Etiprint Inline, Руководство по эксплуатации

Страница: 147 / 188

ATTENTION:
The electronic components of the control panel must not be touched with-
out ESD safety precautions. The controller is sensitive to electrostatic
discharge.
6.2 The control panel
The control panel of the monitor C8600 is a standalone unit that contains a microprocessor. It is
at the same time frontpanel and the control- or administration processor. All settings and adjust-
ments of the Collamat 8600 are programmed and handled in this unit. The settings and adjust-
ments are stored in the control panel even if the power is turned off.
It is possible to install the monitor in two different positions. Due to this the frontpanel can be in-
stalled in two ways. (See figure 12). Therefore the panel is hold with six fixing bolts to the cover. It
can be removed or assembled by clicking it out or in from or onto the cover. Take care to the flat-
cable. It must not be wrenched or squeezed.
Figure 12: Installation modes
When the frontpanel is removed from the cover, keep care that the fixing bolts are not damaged.
After reassembling the frontpanel with the cover, open the fixing bolts a bit with a little screwdriver
or a tool that fits the little slots of the bolts by hand without taking too much force. The frontpanel
must fit tight to the cover.
ATTENTION:
While assembling or disassembling the frontpanel, the copperside or the
frontside can be damaged. You must not use sharp tools like knives or
screwdrivers.
Keep care to the ESD safety precautions.
A B
5999.545-01G 28.02.2006 WM
Page 17 / 65