Collamat Etiprint Inline, Руководство по эксплуатации

Страница: 153 / 188

The supply voltage for the logic and the sensors is connected to terminal X12. Fuse F2 protects
this voltage against overload. LED
LD2 indicates 24V . The voltage 12V and 5V are generated by
the 24V using switching regulators. LED LD3 indicates 12V , LED LD4 indicates 5V .
The 5V and 12V supply's are protected against short connection and overload.
Figure 17: Interfaceboard
The following table shows the voltage and fuse values of the interfaceboard:
Voltage Current Fuse Terminal ~ Terminal = LED
120 V DC 2,2 A F1 : 3.15A X11 X13 LD1
24 V DC 1,5 A F2 : 2,5 A X12 - LD2
12 V DC 500 mA - - - LD3
5 V DC 1 A - - - LD4
6.7.2 Fuses
If the voltage 120V or 24V is missing the corresponding LED is not lit. If the 24V lacks then the
12V and 5V also lack. Each voltage has its own LED. (See also above table). If a voltage is miss-
ing, the corresponding fuse must be checked. The fuses are located beneath the heatsink on the
interfaceboard. If the fuse is blown first check what it caused. The fault must be rectified before
the fuse is replaced.
G L 2
G L 1
F 1
X11 X12
F 2
X13
red+ blk-
~ ~
~ ~
L D 2
L D 3
L D 4
+
+
X 2
X 9
J 1
X 1
+ + +
K 1 K 2 K 3
X 7
X 3
X 6
LD1
X
1
4
2 * violet 2 * orange
1
1
1
1
5999.545-01G 28.02.2006 WM
Page 23 / 65