Collamat Etiprint Inline, Руководство по эксплуатации

Страница: 129 / 188

8 Technical appendix
8.1 Adjusting the predispensing
Predispensing is the length by which the label is pulled forward after detection of the leading edge
of the label. Its value can be entered in 0.1 mm steps. The predispensing is normally used to opti-
mize the label position. Adjust it so, that the label is sticked to the goods at the time, when it has
the same speed as the goods. Only so the label position on the goods is always exact and does
not vary.
If a new value is entered exceeding the old one, the label is pulled forward correspondingly.
But if the new value exceeds the old one, predispensing will be corrected only after one label has
been dispensed.
If the entered predispensing length exceeds the label length, a malfunction of the labeller may re-
sult since the gap between labels is measured at a wrong time.
The minimum predispensing depends on the maximum labelling speed. The labeller needs more
time at high labelling speed to brake the label after having detected its leading edge. The follo-
wing diagram shows predispensing vs. labelling speed:
Predispensing [mm]
Labelling speed [m/min]
Diagram predispensing vs. labelling speed.
C9100
C8600
0 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
5999.530-01F 07.04.2006 WM

42