Collamat Etiprint Inline, Руководство по эксплуатации

Страница: 42 / 188

Etiprint Inline
Commissioning and operating
42
Position setting The position setting function serves to correct the position of the
label on the product. Using this function compensates for laborious
mechanical adjustment to the product sensing on the conveyor
plant.
Adjustment of the position of the label on the product is done via
the menu option
Programming -> Position .
The position value enables the labelling position to be delayed by
up to 1000 mm. During the delay while the position value is being
anticipated, no products are detected or labelled
NOTE!
If the position value is set greater than the product
spacing, not all products will be labelled!
Dispensing single labels
Single labels can also be dispensed via the monitor without
triggering the product sensing. This function is called up via the
menu option
Labelling operation -> Trigger label (see
Collamat 8600/9100 monitor operating instructions)
7.4 Starting up
Proceed as follows with starting up:
Load or replenish labels.
Switch the monitor main switch (at the back) to ON .
Switch on the thermal printer.
The settings have been correctly made and checked (see
section 7.2 and 7.3).
The labelling sequence can be effected via the enable signal
from the product sensing.
7.5 Switching off
To switch off the Etiprint, proceed as follows:
Switch the monitor main switch to OFF.
Switch off the thermal printer.