Collamat Etiprint Inline, Руководство по эксплуатации

Страница: 41 / 188

Etiprint Inline
Commissioning and operating
41
Setting the dispensing speed The Etiprint Inline dispensing speed must be as fast as the
conveyor belt speed.
If the speed is too low, the commodities can become caught
on the labels or the labels torn from the pull-off ledge. This
can tear the backing paper. This gives rise to missing labels.
If the dispensing speed is too high, the labels can form
bubbles and creases on the product. The labelling will be
poor or inexact.
The dispensing speed can be set to a fixed value or synchronised
with the conveyor belt speed. More details on this can be found in
the Collamat technical handbook documentation.
The adjusting and matching of the dispensing speed is described
in the Collamat 8600/9100 handbook monitor operating
instructions.
The dispensing speed is set via the menu option
Programming ->
Speed .
The dispensing speed lies between 3...40/50 m/min (draw
mechanism motor).
The printer speed (print speed) is independent of the dispensing
speed due to the loop hanger.
It must be guaranteed that the spacing selected between the
products is great enough.
Setting the pre-dispensing The pre-dispensing is the length of the label which is pushed out
over the pull-off ledge.
Setting the label pre-dispensing is done via the menu option
Programming -> Pre-dispensing .
If the pre-dispensing value is increased, this becomes effective
directly after adjusting the pre- dispensing. If the pre-dispensing is
set to a smaller value than that previously set, the alteration
becomes effective after one label is dispensed.
NOTE!
If the pre-dispensing is set greater than the length
of the label, this can lead to malfunctioning of the
labeller!