Cognex In-Sight 1721, Руководство пользователя

Страница: 141 / 156

Appendix C
Connecting the Breakout Module
The optional In-Sight Breakout Module (P/N 800-5743) is more convenient than using the
standard Breakout Cable to connect the wafer reader’s power, serial communications,
and I/O lines.
For additional information on connecting a Breakout Module, see Section 8.2.1: Breakout
Port Pin Assignments on page 106 or the
Breakout Module Installation and Reference
manual (P/N 597-0008-xx).
Figure C-1: Breakout Module Connections
To Connect the Breakout Module to the In-Sight Wafer Reader:
1 Verify the 24VDC power supply being used is switched off.
2 Optionally, connect the power and ground wires for the acquisition trigger input and
the discrete outputs into their corresponding terminals on the Breakout Module.
3 Optionally, connect the 9-pin male DSUB connector of an RS-232 serial cable into
the corresponding 9-pin female connector on the Breakout Module.
4 Plug the Breakout Cable’s 15-pin male DSUB connector into the corresponding
female connector on the Breakout Module.
5 Plug the RJ-45 connector of the Breakout Cable into the wafer reader’s Breakout
Port. The cable’s connectors are “keyed” to the notch in the Breakout Port.
6 Plug the wire leads from a 24VDC supply for the +24V power and ground into the
2-pin terminal plug on the Breakout Module. Alternatively, remove the terminal plug
and insert the 2-pin terminal plug attached to the In-Sight power adapter into the
keyed power adapter port on the Breakout Module (Figure C-1).
131