CLIFFORD MATRIX 70.5X, Руководство по установке

Страница: 29 / 70

© 2006 Directed Electronics—all rights reserved
2
relay satellite wire connection guide
The 8 heavy gauge wires coming from the large connector are used to energize high current circuits in the
vehicle. It is crucial that these connections are well-made and capable of handling the current demands. For
this reason, Scotch-Locks, T-taps and other such connectors are strongly discouraged.
PURPLE (+) starter output
Connect this wire to the starter wire in the vehicle. (See Finding the Wires You Need section.)
GREEN starter input
For anti grind or starter kill attach this wire to the key side of the starter wire for anti grind and for the
starter kill to be active.
RED (2) (+)12V input for high current outputs
Remove the two 30-amp fuses prior to connecting these wires and do not replace them until the satellite
has been plugged into the control module. These wires are the source of current for all the circuits the relay
satellite will energize. They must be connected to a high current source. Since the factory supplies (+)12V to
the key switch that is used to operate the motor, it is recommended that these wires be connected there.
NOTE: If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED wire of
the satellite to each feed at the switch.
ORANGE (+) accessory output
Connect this wire to the accessory wire in the vehicle which powers the climate control system.
PINK (+) ignition output
Connect this wire to the ignition wire in the vehicle.