MR3P Series EXPAND SERIAL COMMAND FUNCTION SPECIFICATION
Software Engineer Division
8.5.9 CF_ORGMODE
COMMAND
COMMAND “CF_ORGMODE_%1”[CR]
%1
“XGA1”,”HDTV1080”...Etc
Details
After EXTn is set by PC Control Series Command and CF_SETPCADJ
COMMAND such as CF_FSYNC / CF_TDOTS, this command select original
signal.
Acceptable
“000”[CR]
Response
Unacceptable “101”[CR] ---- When Input is Video Series
8.5.10 CF_PCSTORE COMMAND
COMMAND
“CF_PCSTORE_%1”[CR]
%1
“MODE1”
--- Store current PC Adjust status to MODE 1
“MODE2”
...Store current PC Adjust status to MODE 2
“MODE3”
...Store current PC Adjust status to MODE 3
“MODE4”
...Store current PC Adjust status to MODE 4
“MODE5”
...Store current PC Adjust status to MODE 5
Details
Store current PC Adjust status (each parameter status such as Total dots) to
Mode1-5.
This command operates the same operation as storing to Mode1-Mode5 in
PC Adjust Menu.
(Only valid when it is in the usual Power On state.)
Acceptable
“000”[CR]
Response
Unacceptable “101”[CR] ---- When Input is Video Series
8.6 Input Control Series COMMAND
8.6.1 CF_INPUT
COMMAND
COMMAND “CF_INPUT_%1”[CR]
%1
“1”------------ Select Input-1
“2”------------ Select Input-2
“3”------------ Select Input-3
“4”------------ Select Input-4(Network Viewer)
Details
Select Input.(Only valid when it is in the usual Power On state.)
The operation is the same as the projector button or the remote control
button “INPUT”.
Note 1) When Network Unit is not installed, and Input-4 is selected, the
response will be “103”.
Note) When Input- is set to Monitor Out, and Input-1 is selected, the
response will be “101”.
Acceptable
“000”[CR]
Response
Unacceptable “%%%”[CR]
Page 24 / 53