M
E
RCE
A
RGB
INPUT
OUTPUT
AUD
IN
OUT
PC-CONTROL
S-VIDEO
VID
ME
NU
EN
TE
R
CANCEL
SELECT
POWER
STATUS
ON
/STAND BY
SOURCE
AUTO
ADJUST
Quick Connect Guide
MultiSync VT Series LCD Projectors
Step 1
Connect the supplied 15pin-15pin signal cable.
Step 2
Connect the supplied power cable.
Step 3
Turn on the projector.
RGB
INPUT
OUTPUT
AUDIO
IN
IN
OUT
OUT
PC-CONTROL
S-VIDEO
VIDEO
RGB INPUT
RGB OUTPUT
For older Macintosh computers,
use the supplied pin adapter to
connect to your Macintosh's video
port.
Monitor
Power button
Always power down before
you hook up.
RGB
INPUT
OUTPUT
AUD
IN
OUT
PC-CONTROL
S-VIDEO
VID
NOTE:
To turn off the projector, press and hold the
POWER button for a minimum of two seconds.
Step 4
Set up the Projector.
To adjust the projector's focus or to zoom in and out use the Focus ring or Zoom
lever on the lens.
Focus ring
Zoom lever
M
EN
U
E
NT
ER
CA
NC
EL
SELECT
POWER
STATUS
ON
/OFF
SOURCE
AUTO
ADJUST
RGB
INPUT
OUTPUT
AUD
IN
OUT
PC-CONTROL
S-VIDEO
VID
• If the projected image does not appear square to the screen then use keystone correction
for proper adjustment.
Printed in Japan
78038752
Adjusting the Tilt Foot
1
.
Press and hold the Tilt button on the front of the projector.
2
.
Lift the front edge of the projector to the desired height, and release the button to lock
the Adjustable Tilt Foot.
To fine-tune the image's position vertically on the screen, rotate the foot. Each of the rear
feet height can be changed up to 0.6" (4 mm).
