MR3P Series EXPAND SERIAL COMMAND FUNCTION SPECIFICATION
Software Engineer Division
8.5.5 CF_V-POS
COMMAND
COMMAND “CF_V-POS_%1”[CR]
%1
“0000-nnnn”-- Directly set Vertical Position
“nnnn” means maximum value.
This value is from current Total Line value – display
Line value.
“UP”---------------- Vertical Position setting value +1.
“DN”---------------- Vertical Position setting value-1.
Details
Set vertical position of PC signal. Only valid when it is in the usual Power
On state.) The value set by this Command will not be saved to the
projector. Therefore, when ALL OFF the projector, the value will return to
the original setting. (stays in Stand By mode)
Note:When %1 is directly specified, this command is not enough to execute
for the screen. To show up on the image, issue CF_SETPCADJ COMMAND
Acceptable
“000”[CR]
Response
Unacceptable “101”[CR] ---- When Input is Video Series
8.5.6 CF_DDOTS
COMMAND
COMMAND “CF_DDOTS_%1”[CR]
%1
“0100-”-- Directly set Display Dots value.
“nnnn” means maximum value.
This value is from current Total Dots value-Horizontal
position value
“UP”---------------- Display Dots +1
“DN”---------------- Display Dots -1
Details
Set Display Dots of PC signal
The value set by this Command will not be saved to the projector.
Therefore, when ALL OFF the projector, the value will return to the original
setting. (stays in Stand By mode.)
(stays in Stand By mode.)
(Only valid when it is in the usual Power On state.)
Note:When %1 is directly specified, this command is not enough to execute
for the screen. To show up on the image, issue CF_SETPCADJ
COMMAND.
Acceptable
“000”[CR]
Response
Unacceptable “101”[CR] ---- When Input is Video Series
Page 22 / 53