MR3P Series EXPAND SERIAL COMMAND FUNCTION SPECIFICATION
Software Engineer Division
8.5.7 CF_DLINE
COMMAND
COMMAND “CF_DLINE_%1”[CR]
%1
“0100-nnnn”-- directly specify Display Line value
“nnnn” means maximum.
This value is from current Total Line value – Vertical
Position value.
“UP”---------------- Display Line +1
“DN”---------------- Display Line -1
Details
Set Display Line of PC signal (Only valid when it is in the usual Power On
state.)
The value set by this Command will not be saved to the projector.
Therefore, when ALL OFF the projector, the value will return to the original
setting. (stays in Stand By mode.)
(stays in Stand By mode.)
Note:When %1 is directly specified, this command is not enough to execute
for the screen. To show up on the image, issue CF_SETPCADJ
COMMAND.
Acceptable
“000”[CR]
Response
Unacceptable “101”[CR] ---- When Input is Video Series
8.5.8 CF_SETPCADJ
COMMAND
COMMAND “CF_SETPCADJ” [CR]
%1
N/A
“EXT6”-”EXT60”
Details
1.
Execute the setting value in PC adjustment menu to show up on the
screen.
When %1 is directly set by PC CONTROL COMMAND as below and
SCREEN CONTROL SERIES COMMAND, the command will not be
executed. This command, “CF_SETPCADJ” is to execute the setting
value. (Only valid when it is in the normal Power On state.)
-CF_FSYNC
-CF_TDOTS
-CF_CLAMP
-CF_H-POS
-CF_V-POS
-CF_DLINE
-CF_DDOTS
-CF_FLSCREN
2.
When %1
に
”EXT6” - “EXT60” is set to %1, Content specified %1 by
EXT No.6 (not XGA No.1) will be displayed.
Acceptable
“000”[CR]
Response
Unacceptable “101”[CR] ---- When Input is Video Series
Page 23 / 53