Bull Cedoc NovaScale R440 E2, Руководство пользователя, Страница: 224 / 552

5-26 Installing the Operating System with Express Setup
6.
Select a team type ([Adapter Fault Tolerance]/[Adaptive Load Balancing]).
Click [Next].
7.
Click [Finish].
8.
Click [TEAM: "Team name"] from [Device manager] → [Network adapters] to modify the team. Click [Settings] tab
and click [Modify Team] button.
9.
Refer to the following procedure to set the team member adapter priority status.
– Set Primary
Select the adapter and click the [Set Primary] button.
– Set Secondary
Select the adapter and click the [Set Secondary] button.
NOTE:
Adapter priority configuratioin can be confirmed by the following procedure:
1. Click [TEAM: "Team name"] from [Device manager] → [Network adapters].
2. Click [Settings] and confirm Adapters in the team list.
10.
Click [Test Switch] → [Run test] to confirm the adapter team is properly setup.
Confirm the result in [Test results].
Even if the system is normal, the following mismatch message will appear sometimes. Recheck the switching hub
(L2) port and if there is no problem with the setting, ignore the messages.
– The switch is configured with aggregatedd ports,
but the team type does not support port aggregation.
The switch is configured with VLAN tagging, but
the team has no VLANs.
– Change the team type to SLA, reconfigure the
switch for link aggregation, or disable VLAN
tagging on the switch.
11.
Reboot the system.