Brocade Communications Systems ICX 7250, Руководство по установке оборудования

Страница: 81 / 119

Configuring the Device
∙
Configuration tasks............................................................................................................................................................................................................ 81
∙
PC or terminal attachment.............................................................................................................................................................................................81
∙
Password assignment.................................................................................................................................................................................................... 82
∙
IP address configuration............................................................................................................................................................................................... 84
∙
Connecting network devices....................................................................................................................................................................................... 87
∙
Troubleshooting network connections..................................................................................................................................................................89
∙
Testing connectivity..........................................................................................................................................................................................................89
DANGER
The procedures in this manual are for qualified service personnel.
Configuration tasks
Follow the steps listed in the following table to configure the device. Details for each of these steps are provided on the pages indicated.
TABLE 11 Configuration tasks
Task number Task Where to find more information
1 Attach a terminal or PC to the device. This will
enable you to configure the device through the
command line interface (CLI). PC or terminal attachment on page 81
2 No default password is assigned to the CLI. For
additional access security, assign a password. Password assignment on page 82
3 Before attaching equipment to the device, you
must configure an interface IP address to the
subnet on which the device will be located. Initial
IP address configuration is performed using the
CLI with a direct serial connection. IP address configuration on page 84
4 Once you power on the device and assign IP
addresses, the system is ready to accept
network equipment. Configuring IP parameters for devices running
Layer 3 software
on page 85
5 Test IP connectivity to other devices by pinging
them and tracing routes. Testing connectivity on page 89
6 Continue configuring the device using the CLI.
You can also use Brocade Network Advisor to
manage the device.
FastIron Ethernet Switch Administration Guide
7 Secure access to the device. FastIron Ethernet Switch Administration Guide
PC or terminal attachment
You can access the CLI by attaching a serial cable to the console port. After you assign an IP address, you can access the system
through Telnet or Brocade Network Advisor.
Complete the following steps to attach a management station to the console port.
1. Connect a PC or terminal to the console (mini-USB) port of the device.
To connect the console port to a DB9 port, you need a cable with mini-USB and DB9 connectors.
For information about locating the serial port, refer to Network and management interfaces on page 14.
Brocade ICX 7250 Switch Hardware Installation Guide
53-1003898-02 81