Bionet BM Elite Series, Инструкция по эксплуатации, Страница: 81 / 215

Rev. 5.01
81
into contact with other grounded, conductive parts when connected to the
isolated animal input of the device. Such contact would bridge the animal's
isolation and cancel the protection provided by the isolated input. In
particular, there must be no contact of the neutral electrode and ground.
DEFIBRILLATION — Do not come into contact with animals during
defibrillation. Otherwise serious injury or death could result.
To avoid the risk of serious electrical burn, shock, or other injury during
defibrillation, all persons must keep clear of the bed and must not touch the
animal or any equipment connected to the animal.
After defibrillation, the screen display recovers within 10seconds if the
correct electrodes are used and applied in accordance with the
manufacturer’s instructions.
Patient cables can be damaged when connected to an animal during
defibrillation. Check cables for functionality before using them again.
The peak of the synchronized defibrillator discharge should be delivered
within 60ms of the peak of the R wave. The signal at the ECG output on the
Veterinary Multiparameter monitor s is delayed by a maximum of 30ms.
If the ECG waveform on the screen is too unstable to synchronize with the
animal
’ s heart beat because of the following reason, remove the cause of an
alarm, message, or unstable ECG, and then use a stable ECG lead for
synchronization.
✓
ECG electrode is detached or broken. Lead wire is detached or broken.
✓
Lead wire moves. AC interference, EMG noise or noise from ESU is
superimposed.
✓
Connection cable is broken or has a short circuit. Connector has poor
contact.
INTERFACING OTHER EQUIPMENT — Devices may only be interconnected