Bionet BM Elite Series, Инструкция по эксплуатации

Страница: 129 / 215

Rev. 5.01
129
A-2. Display option EtCO2 parameter wave display setup
A-2-1. Sweep speed Waveform sweep speed setup
6.25mm/s,
12.5mm/s,
25mm/s
A-2-2. Scale
Display waveform scale setup.
The selectable value is the maximum
pressure range shown in the waveform.
When you select a range value, the
selected pressure range value is
displayed below the dotted line above
the two dotted lines in the left middle
of the wave window.
40mmHg (5.3 vol%)
50mmHg (6.6 vol%)
60mmHg (7.9 vol%)
80mmHg (10.5 vol%)
100mmHg(13.2vol%)
150mmHg(19.7vol%)
A-2-3. Fill
Choose whether to fill the waveform
inside
On / Off
A-2-4. Gas pressure unit Choose gas pressure unit
mmHg
kPa
vol%
A-2-5. Use one gas unit
Choose to set the pressure unit for
each gas type
Unit setting menu by gas type appears
when off.
On / Off
A-3. Apnea detect APNEA detection menu On / Off
A-4. Module information Module information menu
A-4-1. Sensor PN The sensor part number PNXXXXXX
A-4-2. OEM ID
The id is a 7-bit identifier which is set
at the factory to a unique value for
each OEM.
0X01
A-4-3. sensor SN The serial number of the module
A-4-4. H/W version
The hardware version number of the
module
A-4-5. Total usage time Total use time of the module.
A-4-6. Last zero time
This is the total time that has elapsed
with the sensor in service the last zero.
Min. display
A-4-7. Pump total time This is the total time the pump has Min. display