Chapter 6 P5 output terminal
81
0
No function
Output terminal has no function
1
Inverter running
When the inverter is running (can be 0Hz), it outputs ON signal.
2
Fault output (stop)
When the inverter fails and the fault stops, the ON signal is
output.
3
Frequency level
detection FDT1
Please refer to the description of function codes P8-19 and P8-
20.
4
Frequency arrival
Please refer to the description of function code P8-21.
5
Zero speed
operation (not
output when
stopped)
When the inverter runs and the output frequency is 0, the ON
signal is output.
This signal is OFF when the drive is in the stop state.
6
Motor overload pre-
alarm
Before the motor overload protection action, the ON signal is
output after the overload pre-alarm threshold is exceeded. Refer
to P9-00~P9-02 for motor overload setting.
7
Inverter overload
pre-alarm
The ON signal is output 10 s before the inverter overload
protection occurs.
8
Set the count value
to arrive
When the count value reaches the value set by PB-08, the ON
signal is output.
9
Specify the count
value to arrive
When the count value reaches the value set by PB-09, the ON
signal is output.
10
Length reached
When the actual length of the detection exceeds that set by PB-
05, an ON signal is output.
11
PLC cycle
completed
The PLC runs a cycle and outputs a pulse signal with a width of
250ms.
12
Cumulative running
time arrives
When the cumulative running time of the inverter exceeds the
setting of P8-17, the output ON signal
13
Frequency limit
When the set frequency exceeds the upper limit frequency or
the lower limit frequency, and the inverter output frequency also
reaches the upper limit frequency or the lower limit frequency,
the ON signal is output.
14
Torque limit
When the inverter is in the speed control mode, when the output
torque reaches the torque limit value, the inverter is in the stall
protection state and outputs the ON signal.
