Beckman Coulter Allegra X-30 Series, Инструкция по эксплуатации

Страница: 57 / 64

PN B05529AE
A-1
APPENDIX A
Installation
Introduction
This chapter contains instructions for installing and connecting the centrifuge. Check that required
clearances and electrical power are available.
WARNING
These centrifuges each weigh 48 kg/106 lb (non-refrigerated model) or 78
kg/172 lb (refrigerated model.) DO NOT attempt to lift or move one of them
without assistance from a lifting device or another person.
Installing the Instrument
WARNING
Do not place the centrifuge near areas containing flammable reagents or
combustible fluids. Vapors from these materials could enter the centrifuge air
system and be ignited by the motor.
WARNING
Maintain a 7.6-cm (3-in.) clearance envelope around the centrifuge while it
is running. No persons should be within this clearance boundary while the
centrifuge is operating. Do not handle or store hazardous materials within the
30-cm (1-ft) area surrounding the centrifuge.
1
The centrifuge ships in a cardboard box on a wooden pallet. For easy access, remove the top of
the box, the foam insert on top of the centrifuge, and then the upper part (sides) of the box and
set them aside.
a. Then, with the help of another person , move the centrifuge from the pallet to its final
position.
• (Note the warning above regarding centrifuge weight.)
2
Position the centrifuge on a level surface, such as a sturdy table or laboratory bench that is able
to support the weight of the centrifuge and resist vibration.
• Refer to Nonrefrigerated Model Specifications or Refrigerated Model Specifications in
CHAPTER 1 for weight.