Bayer HealthCare ADVIA 60, Руководство оператора

Страница: 70 / 128

7. CALIBRATION AND QUALITY CONTROL
Page 7/16 075D0002-01
7.5.4. QC print targets
The commercial control blood target values can be printed at any time. Normally these values are
printed on the assay sheets of your control.
7.5.3. Analysis
This function
2
ANALYSIS allows the operator to run a control as a normal analysis cycle but
with specific LMG thresholds for QC blood (independant from the temperature).
From the QC main menu, move the cursor to the function
2
and press ENTER .
Diag. 7.8
Enter a lot identification when required and press ENTER . An HGB blank reference measurement
is done prior to the analysis. When this cycle is completed, the following message is displayed:
Install one of the 3 levels of control blood tubes in the correct holder position. Close the sample
door to start the analysis if this mode has been selected or close the sample door and press the
cycle button located on the front panel. The analysis is carried out. Results are displayed and
printed out.
From the QC MENU, move the cursor to the function
3
PRINT TARGETS and press ENTER .
The QC targets are printed out.
LOT # : EXIT : ESC
CURRENT : MX223N SAVE : ENTER
ANALYSIS
PRESS THE SAMPLING BAR...
QC 2 ANALYSIS
HH:MM 3 PRINT TARGETS