Barco FSN-1004, Руководство пользователя, Страница: 172 / 246

172 FSN-1004 • User’s Guide • Rev 00
5. System Setup
Universal Input Setup
råáîÉêë~ä=fåéìí=pÉíìé
FSN-1004 system setup: Step 7
In this procedure, you will perform a complete setup on all universal switcher inputs.
Ensure that your inputs are properly connected to the selected
UIC before continuing.

Prerequisite — Ensure that you are familiar with the following menus:
~
Input Menu — Chapter 4, “ Input Setup ,” page 117.
~
Connector Colors — Chapter 4, “ Connector Colors ,” page 119.
~
Input Setup Menu (Universal Inputs) — Chapter 4, “ Input Setup
Menu ,” page 123.

Universal Input Setup — Use the following steps for basic universal input setup:
1. In the Menu Bar , press {System} to access the System Menu .
2. Press {Input Setup} to display the Input Menu .
3. In the Rear I/O View , press the input connector on the UIC that you want to set
up. A yellow highlight is placed around all three input connectors, and in the Input
Table , the input is highlighted.
4. Select the individual UIC connector — either the BNC , HD-15 or DVI . A green
highlight indicates the selection.
5. Press {Input Name} to name (or re-name) the selected input. When the pop-up
Keyboard appears, enter the desired name and press {Enter} on the Keyboard .
6. Press {Error Reporting} to turn error reporting on or off.
~
When on , if an input experiences an error, the connector turns red on the
rear I/O view, the input’s Programmable Display turns red, and the
“ Error ” button appears.
~
When off , the input’s Programmable Display remains green and the
red “ Error ” button does not appear. The connector remains red.

Capture and Timing — Use the following steps to set up universal input capture and
timing parameters:
1. Press {Setup} to display the Input Setup Menu for the selected universal input.
2. Press {Capture and Process} to display the Capture and Process Panel .
3. Press {Auto Acquire} to toggle the Auto Acquire mode On or Off as required.
~
When Off , you can set the resolution using the {Input Format} button.
~
When On , the system attempts to detect the resolution. When a match
is found, the format is applied and the Format field in the table is
7
Note Remember that after a factory reset, UIC inputs are not
mapped to the GUI, but default names are assigned.
Note The {Error Reporting} function works on a connector-by-
connector basis.