Barco FSN-1004, Руководство пользователя, Страница: 37 / 246

FSN-1004 • User’s Guide • Rev 00 37
2. FSN-1004 Orientation
Card Descriptions
~
This is the same as pressing {Factory Reset} on the Reset Menu . In
Chapter 4, refer to the “ Reset Menu ” section on page 161 for details.
~
Use the Com Setup Menu to change the IP address if required. In
Chapter 5, refer to the “ Communications Setup ” section on page 168
for details.
Following are descriptions of all components on the System card’s rear panel:
9) Ethernet Port
One RJ-45 connector is provided for a 10/100 Ethernet connection between the
FSN-1004 and your PC. For multiple Ethernet connections, an Ethernet switch is
recommended. There are two LEDs on the connector:
Figure 2-5. Ethernet Connector
~
When a valid link is present, the amber Link Speed LED indicates
100mb Ethernet speed when lit, and 10mb speed when off.
~
The green Link/Activity LED indicates that a link is present when lit, and
link activity when blinking.
Please note:
~
In Appendix A, refer to the “ Ethernet Connector ” section on page 229
for Ethernet connector pinout details.
~
Use the Com Setup Menu to change the chassis’ IP address. In
Chapter 5, refer to the “ Communications Setup ” section on page 168
for details.
~
Refer to the “ Ethernet Connections ” section on page 38 for more
information about Ethernet.
10) Ref In
One BNC is provided for an analog Reference Input connection. Accepted video
reference signals are black burst, SMPTE bi-level sync and tri-level sync.
11) Loop
One BNC connector is provided for a reference Loop connection, which enables
you to loop the incoming reference signal to the next device in your system. If the
reference
Loop is not used, connect a 75 ohm terminator to the connector.
Link Speed
Link/Activity