Barco FSN-1004, Руководство пользователя, Страница: 184 / 246

184 FSN-1004 • User’s Guide • Rev 00
6. Operations
Quick Setup and Operations
nìáÅâ=pÉíìé=~åÇ=léÉê~íáçåë
For the optimum speed in setting up and operating your FSN-1004 switcher, use the
following steps. For reference, links are provided to the appropriate sections in this guide.
1. Connect power — Ensure that power is properly connected to all FSN-1004
components.
~
Chapter 3, “ PC Connection ,” page 52
~
Chapter 3, “ System Connections ,” page 55
2. Connect inputs — Connect all input sources to the FSN-1004. (Chapter 3,
“ Signal Connections ,” page 64.)
3. Connect outputs — Connect the output(s) of the FSN-1004 to your target
devices. (Chapter 3, “ Signal Connections ,” page 64.)
4. Turn on power — Turn on power to all FSN-1004 components, and to all
peripheral equipment. (Chapter 5, “ Power Up and Status Check ,” page 166.)
5. Factory reset — If you are using the FSN-1004 for the first time, or if you are
using a system that has just returned from another event, perform a full factory
reset. (Chapter 5, “
Return to Factory Default ,” page 167.)
6. Set output format — Set the desired output resolution and frame rate.
(Chapter 5, “ Output Format Setup ,” page 170.)
7. Enable test patterns — If required, use test patterns to verify outputs and make
the necessary adjustments. When complete, turn off the test patterns.
(Chapter 5, “
Output Test Patterns ,” page 171.)
8. Set up universal inputs — As required, set up all universal inputs, and perform
the necessary adjustments. (Chapter 5, “ Universal Input Setup ,” page 172.)
9. Set up user preferences — Complete all user preference choices, as required.
(Chapter 5, “ User Preferences Setup ,” page 180.)
10. Save system configuration — After completing all “system” setups, save the
configuration and back up the system.
~
Chapter 5, “ Saving the Setup ,” page 181.
~
Chapter 5, “ Backing up the System ,” page 181.
11. Set up Multiviewer — As required, set up the Multiviewer and assign sources to
Multiviewer PIPs. (“ Multiviewer Operations ,” page 197.)
12. Set up memory registers — Set up the desired “looks” for your show, and store
them in memory registers as required. (“ Working with Memory Registers ,”
page 189.)
Note Many of these steps were already covered in Chapter 3 and
Chapter 5. As required, use the following list as an easy
check-list for all quick setup requirements.