Barco FSN-1004, Руководство пользователя, Страница: 65 / 246

FSN-1004 • User’s Guide • Rev 00 65
3. Installation
Signal Connections
lìíéìí=`çååÉÅíáçåë
Aux (auxiliary) buses are extra switching buses that allow video signals to be routed from
the FSN-1004 to external equipment. The figure below illustrates the Aux output
connections on the
M/E card’s rear panel, and the SOC rear panel:
Figure 3-12. Aux output connections

Use the following steps to connect Aux outputs from the FSN-1004.
1. Using BNC cables, connect Aux Outputs 1 through 6 to your target auxiliary
devices or monitors. These six outputs run at the system’s native resolution.
2. Use BNC, DVI or HD-15 cables (as required) to connect outputs to your target
devices. Use the
Aux Setup Menu to set the output resolution for each SOC
output. In Chapter 4, refer to the “ Output Setup Menu ” section for setup details.
Please note:
•
Use the Aux Setup Menu to map SOC Aux outputs to a GUI button, and name
Aux outputs (if desired). In Chapter 4, refer to the “ Output Setup Menu ” section
on page 138 for setup details.
Aux Out 1
Aux Out 2
Aux Out 3
Aux Out 4
Aux Out 5
Aux Out 6
SD
I
A
nalo
g
D
V
I D
ig
ita
l
Analo
g
D
V
I D
igit
a
l
2
1
Note:
Use the
Aux Setup Menu
to map
all SOC outputs
and set the
output resolution