Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Bearings
♦ Install needle bearings with lettered side (thicker metal) racing
the fitting tool.
♦ Insert bearing with axle oil or ATF, depending on installation
location.
♦ Do not interchange the outer or inner races for the same size
bearings.
♦ Always replace the tapered roller bearings on one shaft to‐
gether and use new bearings from a single manufacturer.
Adjusting Shims
♦ Measure the shims at several locations with a micrometer.
Tolerance variations make it possible to find the exact shim
thickness required.
♦ Check for burrs and damage. Only install flawless shims.
3.4
Contact Corrosion
Contact corrosion can occur if non-approved fasteners (bolts,
nuts, washers, etc.) are used.
For this reason, only fasteners with a special surface coating may
be installed.
In addition, rubber or plastic parts and adhesive are made of ma‐
terials that do not conduct electricity.
If you are not sure about the suitability of parts, then use new
parts. Refer to the Parts Catalog.
Note
♦
Original replacement parts are recommended because they
have been tested.
♦
It is recommended to use Audi accessories.
♦
Damage resulting from contact corrosion is not covered by the
warranty.
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
8
Rep. Gr.00 - General, Technical Data
