Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Install the -VAS6262A- into the ATF check and fill hole
-arrow-.
– Fill the ATF using the adapter until the ATF starts to leak out
of the check and fill hole.
– Move the selector lever into “P”.
– Start the engine, wait 20 seconds and then turn it off.
– Fill the ATF again until it starts to leak out of the hole.
– Start the engine.
– Fill the ATF again using the adapter until the ATF starts to leak
out of the check and fill hole.
– Tighten the old plug for the ATF check and fill hole.
– While pressing the brake pedal and with the vehicle idling, shift
through all the selector lever positions (“P”, “R”, “N”, “D”, “S”
or “D/S”) leaving each position engaged for at least 3 seconds.
– Move the selector lever into “P”.
– Check the ATF level and correct if necessary. Refer to
⇒ “6.2 ATF Level, Checking”, page 110
.
Note
Observe all notes and test requirements for “Checking ATF level
and correcting”.
– Install the rear noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
116
Rep. Gr.37 - Controls, Housing
