Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.3.2
Gear Oil Level, Checking, Transfer
Case, Transmission with Separated Oil
System
Special tools and workshop equipment required
♦ Pressurized Gearbox Oil Filler Kit - VAS6617-
♦ Used Oil Collection and Extraction Unit - VAS6622-
♦ Protective eyewear
Caution
♦ Risk of damaging transfer case and the front axle differ‐
ential through incorrect oil level.
♦ Depending on the version there are transmissions with
separate or combined oil systems.
♦ For vehicles with combined oil systems the steps for it
must be followed, because the oil level from the transfer
case and the front axle differential are dependent on one
another.
Procedure
• Gear oil temperature: approximately 20 °C (68 °F) (room tem‐
perature).
• The engine must be switched off when working.
• Move the vehicle onto a four-column shop hoist or over a work
pit so it is completely level.
• The transmission must be still for at least 15 minutes to make
sure the oil settles internally.
• Transmission in “P”.
• The parking brake button should be activated to close the
electro-mechanical parking brake.
• Tightening specification. Refer to
⇒ “2.1 Overview - Drain and Inspection Plugs for Gear Oil”,
Note
♦
General repair instructions. Refer to
⇒ “3.3 General Repair Information”, page 6
.
♦
Pay attention to clean working conditions for the transmission.
Refer to
⇒ “3.1 Clean Working Conditions, Guidelines”, page 5
♦
Follow the disposal requirements.
♦
Replace the ATF drain plug and seal.
♦
Replace the plug for the ATF check and fill hole.
– Place the -VAS6617- under the transmission.
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
154
Rep. Gr.39 - Final Drive, Differential
