AT&T MERLIN LEGEND Release 3.1, Руководство по системному программированию

Страница: 399 / 887

Lines and Trunks
Programming Procedures
4–27
Console Display/Instructions Additional Information PC
6 Enter the port numbers that have ground-start or loop-start trunks connected.
400 and 408 ports:
n = 1 to 4; 800 ports: n = 1 to 8.
**** Start Slot xx:
**** = option name selected in Step 5
Enter port no. (1-8)
xx = slot number entered in Step 3
NOTE:
If you get the Trunk Busy message, wait
Backspace Next
for an idle condition or exit system
Exit Enter
programming and try again later.
Dial or type [ n ].
Û
7 Continue to assign trunk types or go to Step 8.
Select
Next Next
.
9
Return to Step 6. The next slot number
will be displayed on Line 1.
8 Save your entry.
Select
Enter Enter
.
0
9 Return to the System Programming menu.
Select
Exit Exit
two times.
55
Outmode Signaling for Loop- or Ground-Start
Trunks
Use this procedure to identify either touch-tone signaling or rotary-dial signaling
for outgoing calls placed by using the specified loop- or ground-start trunk.
NOTE:
Since the factory setting is touch-tone, this procedure is not required if your
system has only touch-tone lines/trunks.
Summary: Outmode Signaling for Loop- or
Ground-Start Trunks
Programmable by System manager
Mode Loop-Start: All; Ground-Start: Hybrid/PBX only
Idle Condition Not required
Planning Form Form 2c, System Numbering: Line/Trunk Jacks
Factory Setting Touch-tone
Valid Entries Touch-tone, Rotary
Inspect No
Copy Option Yes