AT&T MERLIN LEGEND Release 3.1, Руководство по системному программированию

Страница: 33 / 887

Programming Procedures
Programming Basics
1–17
Console Display/Instructions Additional Information PC
4 For additional toll services, go to Step 1; then continue with Step 5.
5 Return to Step 4 of the main procedure.
Each branch procedure is self-contained and begins with Step 1. Be sure to
complete all of the steps in a branch procedure before you return to the main
procedure.
The examples in the following text refer to Steps 1 through 5 of the
l
AT&T Toll
Procedure (above), which is a branch of the Network Services procedure.
When you are to repeat a step within the branch procedure , you are instructed to
go to that step. For example, at Step 4 of the branch procedure you would go
back to Step 1 of the branch procedure and repeat branch Steps 1 through 4 for
additional toll services. If you did not need to enter any other toll services, you
would continue with Step 5 of the branch procedure.
When a branch step instructs you to return to the main procedure, the branch
procedure is complete. At Step 5 of the branch procedure you would return to
Step 4 of the Network Services procedure to continue. In some cases, you can
select
Exit
(
5
on the PC) to return to the menu where the branch began; these
are noted in specific programming procedures. In cases where completing the
branch procedure also completes the main procedure you will be instructed to
select
Exit
(
5
on the PC) one or more times to return to the system
programming menu.
Single or Block Items
Branching is also used when you can select between programming a single item
or a block of items, such as a single line or a block of lines, as shown in sample
Step 5.
Console/Display Instructions Additional Information PC
5 Specify the line(s).
l l u u
B-Channel Group xx:
xx
= number entered in Step 2
Assign lines
_
Lines 01-20 Entry Mode
_
To select a single line, go to
_
Lines 21-40
l
Single Line Procedure.
_
Lines 41-60
_
Lines 61-80
To select a block of lines, go to
Exit
u
Block of Lines Procedure.
6 Continue with this step when you complete the branch procedure.