ashtech HDS800, Справочное руководство

Страница: 387 / 678

371
Set Command Library
Parameters
Comments
• Only fractional parts of GLONASS carrier phase biases are
of practical importance
.
• Running one of these commands on a receiver already
stored in the list of user-defined receivers will save all the
submitted parameters to backup memory and keep all the
others unchanged.
• You may not run the two commands (GB1 and GB2) for a
given user-defined receiver. If you run just one of them,
then the parameters corresponding to the other command
will all be assumed to be invalid (i.e unknown). All user-
defined receivers created from this receiver will also
inherit these invalid parameters.
• The board will interpret any missing parameter in a
command as a parameter for which there is currently no
known valid value for this parameter.
RCP,DEL: Deleting User-Defined Receiver Name
Function
This command is used to delete a user-defined receiver
name.
Command Format
Syntax
$PASHS,RCP,DEL,s1[*cc]
Parameters
Parameter Description Range
s1
Name of user-defined receiver for which
GLONASS biases must be defined (case sensi-
tive)
31 characters
max.
f2
When a linear pattern is assumed for GLONASS
biases, f2 represents the delta bias between two
adjacent GLONASS frequency numbers. Full range of
Real variables
allowed
f3-f16
When an arbitrary pattern is assumed for
GLONASS biases, f3-f16 represent biases for
GLONASS frequency numbers from -7 to 6 Full range of
Real variables
allowed
f17
Pseudo-range bias (in meters) between GPS
and GLONASS constellations
*cc Optional checksum *00-*FF
Parameter Description Range
s1
Receiver name you want to delete (case sensi-
tive) 31 characters
max.