ashtech HDS800, Справочное руководство

Страница: 63 / 678

47
Using the Web Server
After the connection has successfully been established,
the Web Server
Home
tab appears in your web browser.
5. Click on the
Status
tab. You are then asked to enter the
login and password of your connection profile (user or
administrator). After you have successfully entered these
two parameters, you can start using the Web Server. If you
are the administrator, you are also allowed to access and
fully use the
Configuration
tab.
Configuring HDS800 to Deliver Heading Measurements
Setting the
Heading Mode
• Run the Web Server.
• Click on the
Configuration
tab.
• Enter the administrator username and password, then
click
OK
.
• Click on
Heading
in the left-hand part of the web page.
• For each of the two GNSS antennas connected to the
receiver, select the model used (
Antenna 1
and
Antenna 2
fields). Make sure antennas have been set up as described
in
GNSS Antenna Setup for Heading Measurements on
page 2
2
.
• If you wish the receiver to output heading at a fast rate
(20 Hz) and this firmware option is active in the receiver,
check the
Fast Output
option. With this option disabled,
heading is output at 2 Hz.
• Change the default value (5°) of
Position Elevation Mask
if
necessary.
• Change the default settings for GLONASS and SBAS
tracking, if necessary.
• Select “Internal” as the heading mode used. “Internal”
implies the use of the two embedded GNSS boards.
• Enter the parameters that result from the particular setup
of your two antennas:
– Baseline length (in m)
– Azimuth offset (in °)
– Elevation offset (in °)
You may prefer to let the receiver determine the baseline
length by itself (recommended). In that case, instead of
entering the measured baseline length (which should be
known to within 1 cm), enable the
Auto Calibration
option.