ashtech HDS800, Справочное руководство

Страница: 291 / 678

275
Set Command Library
• The settings you make by running $PASHS,CFG have
priority over those you make using $PASHS,GPS (for
GPS), $PASHS,GLO (for GLONASS) and $PASHS,GAL
(for Galileo). After you have run $PASHS,CFG to change
the GNSS tracking configuration, GNSS tracking is set to
the appropriate defaults, depending on the installed
firmware options.
• Using $PASHS,CFG to change the GNSS tracking mode
does not affect the output of periodical messages as long
as they are compatible with the selected mode. For
example, if “SSL” is selected and a message is then
programmed through $PASHS,NME,POS,A,ON, then
changing the GNSS tracking mode to “DSL” will not affect
the message at all.
• The L2C signal has priority over the L2P signal if both
signals are available for a given satellite (2LW mode)
• Whenever $PASHS,CFG is run, appropriate defaults are
restored.
Example
Setting the receiver in dual-signal configuration:
$PASHS,CFG,DSL*40
Relevant Query
Command
$PASHQ,CFG
$PASHQ,PAR
See also
$PASHS,GPS
$PASHS,GLO
$PASHS,SBA
$PASHS,GAL
CMD,LOD: Running a List of $PASH Commands
Function
This command is used to run the complete list of $PASH
commands stored in a file found in the USB key currently
connected to the receiver.
This implies that the file (in text editable format) should have
first been saved to that key before connecting the key to the
receiver’s USB port.