ashtech HDS800, Справочное руководство

Страница: 71 / 678

55
Using the Web Server
Direct IP Via
Ethernet
• First, click on the
Connections
>
Ethernet
submenu.
• Set the following Ethernet parameters to allow the receiver
to access the network through its Ethernet port:
–
DHCP
: Enabling this option means the local network to
which the receiver is connected will automatically
allocate a dynamic IP address to the receiver. If this
option is disabled, you need to define the receiver’s
static
IP address
, and give information about the local
network (
Subnetwork Mask
and
Gateway
). You may need
to be assisted by a network expert -or IT Manager- to
define these parameters (as well as the three
parameters below).
If you activate the
DHCP
option, then it’s a good idea to
define a hostname for your receiver and declare it to
DynDNS (see
DynDNS
frame at the bottom of the page).
DynDNS is a free service that will make sure the
dynamic IP address allotted to the receiver by your ISP
is always attached to your receiver’s hostname. This
requires that you open an account on DynDNS. For
more information on this service, see Creating an
Account on Dyn.com on page
84
.
–
DNS 1 IP Address
: If DHCP is disabled, enter the IP
address of the primary DNS providing the
correspondence between the receiver host name and
its IP address.
–
DNS 2 IP Address
: If DHCP is disabled, enter the IP
address of the secondary DNS providing the
correspondence between the receiver host name and
its IP address
– (
MAC Address
is a read-only field showing the hardware
identification of the receiver’s Ethernet port.)
• Ignore the
Port I Settings
frame.
• Click on the
Configure
button to let the Web Server load all
your new parameters to the receiver.
RTK Corrections
Ethernet
HDS800
Base
IP address
or server name
(Client)
Internet