ashtech HDS800, Справочное руководство

Страница: 231 / 678

215
Integrating HDS800 into Your Application
Ending the NTRIP
Connection
Direct-IP Rover (Via Modem)
Script
Query the current mount point:
$PASHQ,NTR,MTP
$PASHR,NTR,MTP,NAN1*05
Action Command
Action Command
Ending the NTRIP connection:
$PASHS,NTR,MTP,OFF
$PASHR,NTR,OK*14
Action Command
Set the name of the antenna connected to
the receiver: $PASHS,ANP,OWN, ASH111661
$PASHR,ACK*3D
Set the antenna reduction mode to ON, so
that all coordinates refer to the ground
mark:
$PASHS,ANR,ON
$PASHR,ACK*3D
Enter the antenna height (e.g. a vertical
height of 2.0 meters was measured): $PASHS,ANT,0,0, 2
$PASHR,ACK*3D
Set the modem and GPRS parameters
(PIN code, band, APN settings):
$PASHS,MDM,PAR,PWR,AUT,
PIN,
1234 ,BND, 1 ,APN, orange.fr ,
LGN, orange ,PWD, orange
$PASHR,ACK*3D
Set the modem in GPRS and TCP/IP
modes: $PASHS,MDM,PAR,PTC,1,IPT,0
$PASHR,ACK*3D
Turn on the modem (unless the modem has
been set in automatic power mode): $PASHS,MDM,ON
$PASHR,ACK*3D
Initialize the modem. Wait a few seconds
until the receiver can respond to this com-
mand.
NOTE: If the initialization fails, the message
$PASHR,MDM,INI,FAILED*7D is returned.
$PASHS,MDM,INI
$PASHR,MDM,INI,OK*7A
Set the receiver to be a rover:
$PASHS,CPD,MOD,ROV
$PASHR,ACK*3D
Ask the modem to connect to the server:
NOTE: The RIP field may contain either an
IP address or a host name.
$PASHS,DIP,PAR,...IPP,E
$PASHR,ACK*3D
$PASHS,DIP,ON
$PASHR,ACK*3D