ashtech HDS800, Справочное руководство

Страница: 92 / 678

76
Using the Web Server
–
Password
: Enter the password of the mobile
communication provider.
• Click on the
Configure
button.
• Now please follow all the steps described in section
General Parameters on page
67
and then proceed with the
steps below.
• Still on the
Base Setup
page, make sure the
Connection
fields in the
Serial Port x
panes are all set to “None/Cable”
• In the
Network 1
pane, choose “Modem Direct IP - Port E”
in the
Connection
field.
• The base being necessarily a client, enter the information
(
Connect Now
,
Address
,
Port
) allowing it to connect to the
rover (the server) to which it is supposed to deliver
corrections. No
Login
or
Password
is needed in this case.
Enable
Connect Now
to allow the receiver to establish the
connection right after you have clicked on
Configure
.
• In the
Differential Stream 1
pane, choose
Port
= “E - Modem”
as the output port delivering the generated differential
data. In the
Message
field, choose the type of differential
message provided through this port (ATOM, RTCM, CMR,
CMR+ or DBEN).
NOTE: The receiver has been designed to offer two
separate and independent differential data outputs. Each
one can output a specific type of differential message. If
only one output is used, select
Port
=“None” for the other
output.
• Click on the
Configure
button to let the Web Server load all
your new parameters to the receiver. You have now
reached the end of the configuration phase.
Direct IP Via
Ethernet
• First, click on the
Connections
>
Ethernet
submenu.
• Set the following Ethernet parameters to allow the receiver
to access the network through its Ethernet port:
HDS800
RTK Corrections
Ethernet
Users
IP address
or server name
Internet
(Client)