ashtech HDS800, Справочное руководство

Страница: 74 / 678

58
Using the Web Server
–
Address
,
Port
,
Login
,
Password
: Enter the information
allowing the receiver to connect to the NTRIP caster.
This information should have been passed on to you
earlier by the administrator of this service.
–
Load Source Table
button: Click on this button after you
have entered the information about the NTRIP caster.
As a result, the list of available sources from this caster
appears just underneath. (See example below.)
Select the desired source by simply clicking on the
corresponding row. The resulting mount point then
appears in the
Mount Point
field located above the
Load
Source Table
button.
–
Send NMEA
: Check this button when the rover operates
in a VRS network so that it can return its position to the
network through an NMEA message. Keep it cleared in
all other cases. (This option is automatically enabled
when you select a mount point for which the NMEA
message is requested.)
• At the bottom of the page, in the
Differential Port
pane,
select the
Automatic
option to let the receiver detect the
incoming differential stream automatically.
NOTE:
Automatic
is the recommended choice for the
Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.
• Click on the
Configure
button to let the Web Server load all
your new parameters to the receiver. You just have now to
define the output messages (see
Defining Output
Messages on page 63 ).