Arkray AUTION MAX AX-4030, Руководство по эксплуатации

Страница: 198 / 206

AX-4030
5-7
AUTION MAX AX-4030 OPERATING MANUAL
Measurement-Related Messages 5.4
This section lists the messages that can possibly appear on the printed results reports and abnormal
results lists when incorrect results are obtained.
5.4.1 Results-Related Errors
(Printed Results Reports: on the lowest line)
The instrument cannot produce any results when measuring abnormal samples such as drug-
administered or dense turbid urine. In such a case, an appropriate error message is added to the end
of the results reports (see page 2-50). See the table below to solve the problem. If the error persists,
turn off the power and contact your distributor.
Wear protective gloves to prevent exposure to pathogenic microbes before
any operation that may expose you to samples.
Discard used samples, test strips and protective gloves in accordance with
local regulations for biohazardous waste.
No sample
Description No sample was detected.
Cause
The sample tube is empty.
Remedy Ensure the sample tube contains at least 2 mL of sample, and the sample level is 40 mm
above the bottom of the tube.
↓
Retry measurement.
Skipped
Description The sample was not measured.
Cause
. The host instructs the instrument not to measure the sample.
2. The sample tube is not labeled with a barcode, or the label is too dirty to read.
3. The barcode is labeled out of position.
4. The built-in barcode reader is out of order.
Remedy . There is no problem with the instrument.
2. Newly label the sample tube, and retry measurement.
3. Reattach the label in the correct position and retry measurement.
4. Turn off the power, and contact your distributor.
Reflection light intensity drift
Description Light intensity varied during measurement.
Cause
Outside light is penetrating the optical block.
Remedy Install the waste box correctly (see page -29), and retry measurement.