ARAG BRAVO 300S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 16 / 52

16
8.5 Connection of sensors and other available functions
Fix the connectors to the relevant functions according to the initials indicated in your assembly general diagram (Par. 6.1).
Harness cables are marked with a symbol denoting their functions: please see the table for correct harness instructions.
Use ARAG sensors: use of unsuitable sensors not provided by ARAG automatically voids the warranty.
ARAG is not liable for damages to the equipment, persons or animals caused by failure to observe the above instructions.
direct connection harness
ITEM MAIN CONNECTION ALTERNATIVE CONNECTION
f Flowmeter --
G
Main valve --
m
Pressure sensor --
p
Main valve --
r
Foam marker --
s
Speed sensor --
t
Filling flowmeter RPM sensor Pump Protector
X
Level sensor --
rcu harness
WARNING:
the secondary connection “T” shall be used only
if connection “X” is already occupied by another
sensor.
Do not use the secondary input “T” if no sensor is
connected to the “X” input, otherwise the computer
will not be able to acknowledge the Pump Protector
sensor.
ITEM MAIN CONNECTION ALTERNATIVE CONNECTION
f
Flowmeter --
G
Main valve --
L
Level sensor --
m
Pressure sensor --
p Control valve --
r
Foam marker --
s
Speed sensor --
t
Filling flowmeter Pump Protector
X
RPM sensor Pump Protector
- The products are supplied with the sensor installation instructions.
The following speed sensors can also be used as RPM sensors:
• inductive speed sensor ( Code 467100.086);
• magnetic speed sensor ( Code 467100.100).
- Connection of:
• flowmeter;
• pressure sensor;
• level sensor
• Pump Protector;
• filling flowmeter;
• RPM sensor;
• foam marker.
All ARAG sensors use the same type of connector. Connect the sensor connector to the relevant harness; make sure it is correctly fitted and push it
until locking it.
Fig. 25 Fig. 26
INSTALLATION