18
9
setup
9.1
Tests and checks before programming
Before computer programming, ensure:
• that all components are correctly installed (control unit and sensors);
• the connection to the power source;
• the component connection (main control unit and sensors).
Failure to correctly connect system components or to use specified components might damage the device or its components.
9.2
Computer switching On/Off
• Ordinary switching on
Software version
Job screen
Fig. 30
Keep key
ESC
pressed until switching on the display: after the software version, Bravo 300S displays the job screen (Fig. 30).
NOTE: The starting screen changes according to the model you have purchased.
• Switching on to activate the advanced setup
Fig. 31
Contemporaneously press the key sequence until switching on the Bravo. Release key
ESC
keeping pressed the arrow keys until the display shows the menu
ADVANCED SETUP
(Fig. 31).
• Switching off
Fig. 32
Keep key
ESC
pressed until the display shows the message
WAIT:
saving data
.
Release the key and wait for the saving process to complete (Fig. 32); after a few seconds the computer turns off.
During switching off do NOT press any other key and do NOT disconnect the power supply until Bravo 300S turns off.
WARNING: ALWAYS use the special key to switch off the computer; otherwise ALL data concerning the spraying and the
programming will be lost.
PROGRAMMING
Par.9.3
Quick reset of
change
Menu item scrolling or
Data increase/decrease
Confirms access to menu
or data change
Quits the menu or
data changes
