Allied Telesis AT-SB*81CFC960, Руководство по установке

Страница: 236 / 356

Chapter 11: Verifying the Hardware Operations of the Chassis
236 Section II: Installing the Chassis
2. Compare the version number displayed by the SHOW VERSION
command with the information in Table 28 on page 92 to confirm that
the AlliedWare Plus Operating System on the controller card supports
all the hardware components in the chassis. If necessary, update the
management software on the controller card.
3. To display the status of the power supplies, fan module, and AT-
SBx81CFC960 Controller Fabric Cards, use the SHOW SYSTEM
ENVIRONMENT command in the User Exec or Privileged Exec mode.
The Status column in the display provides the states of the modules.
Components are operating normally when they have an “Ok” status.
Note
The next command, SHOW CARD, has to be performed from the
Privileged Exec mode. If you are still in the User Exec mode, enter
the ENABLE command to move to the Privileged Exec mode. The
prompt for the mode is “awplus#”.
4. To display the status of the line cards, use the SHOW CARD
command in the Privileged Exec mode. A line card has a state of
“Online” when it is operating normally. An example of the status
information is shown in Figure 155.
Figure 155. SHOW CARD Command
5. To display the states of the individual ports on the Ethernet line cards,
use the SHOW INTERFACE STATUS command in the Privileged
Exec mode.
6. To check the status of PoE on the ports of the AT-SBx81GP24 Line
Card, use the SHOW POWER-INLINE or SHOW POWER-INLINE
INTERFACE command in the User Exec or Privileged Exec mode.
For information about the command line interface, refer to the
Software Reference for SwitchBlade x8100 Series Switches on the
Allied Telesis web site.
awplus# show card
Slot Card Type State
---------------------------------------------------
1
AT-SBx81GP24 Online
2 AT-SBx81XS6 Online
3 AT-SBx81GP24 Online
4 AT-SBx81GS24a Online
5 AT-SBx81CFC960 Online (Active)
6 AT-SBx81CFC960 Online (Standby)