Airwell KXV Series, Инструкция по эксплуатации

Страница: 217 / 380

Engineering manual
217
1.4.6 Transfer and fix up outdoor unit
CAUTION

Please carry the unit to installation place with its initial packaging as best as possible.

Be careful when hanging the unit with sling (for example), because the center of gravity is not the epicenter of this
unit, and some methods should be taken to avoid its overturn.

The gradient shouldn’t exceed 45° during the unit transit. Don’t store the unit in a decumbent way.

Bring the unit slowly by grabbing the left and right grips.

Place your hands on the corner instead of holding the suction inlet in the side of the case, otherwise the case could
be deformed.

Take care not to touch the rear fins with your hands. Or it will hurt your hands and damage the unit.
A.
How to prevent overturn
If it is necessary to prevent the unit from falling over, the following method can be for your information:

Prepare all 4 wires as indicated in the drawing

Unscrew the top plate at the 4 locations indicated A and B

Put the screws through the nooses and screw them back tight
B.
Fix up outdoor unit

Before installation, check strength and horizon of the base for preventing abnormal vibration and noise.

According to the following base diagram, fix the base firmly with the anchor bolts. (Anchor bolt, nut: M10×4 pairs)

Concrete Basic as following:
Set the out margin of the anchor bolt to 25mm or less.
A
Location of the 2 fixation holes on the front side
B
Location of the 2 fixation holes on the front side
C
Wires: field supply
Chart 1-15
Chart 1-16
Chart 1-17