Airwell KXV Series, Инструкция по эксплуатации

Страница: 160 / 380

Engineering manual
160
4.9.2 Special Tips
A. MODE/RESET BUTTON

If filter LED is ON, a short pressing of the mode button will reset filter timer and turn off the filter clean LED.

If filter LED is OFF, mode button is used for forced operation mode in Cooling-Heating-OFF as circle.

If filter LED is OFF, long pressing the button, will allow to enter diagnostic mode. For details please contact the
technician.
B. OPERATION INDICATOR

Lights up in green during operation.

Blinks once when receiving message from remote controller.

Blinks for 3 seconds when cool mode is selected through mode button.

Blinks when the unit is in protection or fault state.
C. POWER INDICATOR

Lights up in red whenever power is on.

Blinks for 3 seconds when heat mode is selected through mode button.
D. TIMER INDICATOR

Lights up in yellow when TIMER mode at remote controllers is used.

Blinks after power off when Timers is set to show that timer counting is lost.
E. FILTER INDICATOR

Lights up when air filter requires cleaning.
F. SIGNAL RECEIVER

Receive
If the air-conditioner can not be operated by the Remote Control , it can be turned on for cooling or heating, or
completely turned off , by every short pressing on MODE button (A) on the air-conditioner . The MODE button will
change the operating status of the unit between - COOLING - HEATING - OFF positions. Enter into diagnostic mode by
pressing MODE button at display for long time.
Chart 4-12